Prince George Vintage Motorcycle Club
Technical Section => Engine => Topic started by: Fritz on March 04, 2012, 01:13:00 PM
-
Good Job...Thanks Jeff.... ;D
The Pan lost a Valve guide and jammed the Oil pump last Fall....These are some pics of the Head repair.....
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/02292012277.jpg)
This pic shows the chunk of head( Guide Hole ) that was cracked off ....with a little help of a smiling guy and a hammer...
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/02292012279-1.jpg)
Welding it up......
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/02292012283.jpg)
After the weld
Needed this pan jig....(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/02292012284.jpg)
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/02292012286.jpg)
Boring out the hole....ended up being dead centre of the seat....just had to lap valve in
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/03022012289.jpg)
cleaning up the gasket surface
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/03022012290.jpg)
Made the guide and installed it nicely.....a little bit of porting....
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/03032012294.jpg)
Ready for install....waiting for some seals....some are saying NOT to use them though....
**
This pic is the Old guide that packed up in my Oil pump.....
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/OKEEF004.jpg)
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/P8037153.jpg)
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/P7297111.jpg)
(http://i582.photobucket.com/albums/ss263/ironpan65/Pan/P8037156.jpg)
-
Jeff's got skills - but he's got no heat.
-
Yes NO HEAT..... ;D I wear the winter gear when i go over. Nice job on the Pan Kurt!!