Prince George Vintage Motorcycle Club

General Category => General Discussion => Topic started by: Olafskii on February 18, 2018, 07:44:18 PM

Title: Looking for a bit of welding help (will bring beer, 'za)
Post by: Olafskii on February 18, 2018, 07:44:18 PM

My GT750 project is slowly progressing and I'm now at a point that I need an engine stand.  The stand supports the engine from the frame mounting points.  These engines have the water pump underneath.  The stand allows moving the engine to a vertical position that allows working on the water pump.  The stand also prevents the engine from resting on the water pump when sitting flat. 

I'm building the stand that all the guys in the UK are using--attached is a picture.  I've cut all the angle material, and drilled the requisite holes.  Can anyone help with the welding.  I'll bring the beer and pizza.  Let me know.  Thanks

Olaf
 

Title: Re: Looking for a bit of welding help (will bring beer, 'za)
Post by: Dennis on February 19, 2018, 01:40:59 PM

I can do that.  No problem if you have the bits cut.  My shop is in dirty metal fab mode right now, so this would be no imposition at all.

Maybe Saturday?

Peace & Millermatic, Dennis

Title: Re: Looking for a bit of welding help (will bring beer, 'za)
Post by: Olafskii on February 19, 2018, 07:53:51 PM

Say 12:30-ish this Saturday?  I'll be there with the parts.  + bzzr, and 'za (of course)  Thanks

Olaf

Title: Re: Looking for a bit of welding help (will bring beer, 'za)
Post by: Dennis on February 26, 2018, 03:25:05 PM

Done.

(https://i.imgur.com/FDr1EJB.jpg)

(https://i.imgur.com/g6EKUox.jpg)

Peace & Grease, Dennis