Prince George Vintage Motorcycle Club

General Category => General Discussion => Topic started by: Olafskii on March 13, 2016, 08:58:38 PM

Title: New lift in Olaf's shop
Post by: Olafskii on March 13, 2016, 08:58:38 PM

I found a lift that doesn't take up the space that table lifts do.  Made in the UK.  I ordered it a couple of months ago and it arrived last week.  It was not cheap but it is well made.  No weld spatter, cold fusion, good paintwork and dimensionaly accurate.  It's easy to roll around when there is no bike on it.  Weighs only 86#.

Olaf 

Title: Re: New lift in Olaf's shop
Post by: Hans on March 14, 2016, 10:00:21 PM

How does it hold the bike sideways like that?    ;D

Title: Re: New lift in Olaf's shop
Post by: fj1200 on March 14, 2016, 11:41:40 PM

The other question that comes to mind is,  did you use concrete anchors or drywall screws to fasten it to the wall?